To test you kitchen ceiling-mounted heat alarm, follow the instructions below. A full manual is available to download from this page.

ALARM TEST
a) Briefly press the test button in the centre and release.

b) The unit will give an audible alarm consisting of 2 cycles of 3 loud beeps, then stop
automatically.
c) The red LED on the alarm will flash rapidly during the audible signal.

NOTE: The test button tests the alarm’s smoke sensing circuit. There is no need to test your alarm
with smoke. If your smoke alarm fails
to give an audible test signal, please refer immediately to the trouble shooting guide at the end
of this manual.
WARNING: As with all electronic alarm products you should test your smoke
alarm every week.
If your WST-630 is interlinked with other smoke alarms, we recommend that every individual smoke
alarm is tested during the weekly test.
a) Briefly press the test button in the centre of the smoke alarm and release.
b) The unit you are testing will give an audible alarm consisting of 2 cycles of
3 loud beeps, then stop automatically. The red LED on this alarm will flash rapidly (once per
second) during the audible alarm. All interlinked alarms will give an audible alarm consisting of 2
cycles of 3 loud beeps, then stop automatically, indicating the test is complete. The red LED on
all interlinked alarms will not flash rapidly. If any alarm fails to self-test, see Troubleshooting
on page 16 of the attached manual.